![]() ![]() ![]() Local Port: Eth1/38 MAC Address= 88-f0-31-bf-34-bfįrom the GUI point of view, the port-channel is seen in Fabric/Access policies: Pod2-leaf2# show lacp interface ethernet 1/38 | egrep -A8 "Local" | egrep "Local|LACP" Pod2-leaf2# show lacp interface ethernet 1/37 | egrep -A8 "Local" | egrep "Local|LACP" I - Individual H - Hot-standby (LACP only) Pod2-leaf2# show port-channel summary interface port-channel 3įlags: D - Down P - Up in port-channel (members) pod2-leaf2# show port-channel summary interface ![]() However, this port-channel is running default LACP timers as shown by issuing the command on an ssh session on the ACI leaf. The ACI fabric is already configured with a port-channel running LACP on ACI leaf name pod2-leaf2 port 1/37-38. Background InformationĪt the beginning of this configuration guide, the ACI fabric is already configured with a port-channel on Leaf2 port 1/37-38 going to a Nexus6000 device. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. However, all screenshots and commands shown here were done on an ACI fabric running 1.1(4e) software. This document is not restricted to specific software and hardware versions. There are no specific requirements for this document. This document describes how to configure fast Link Aggregation Control Protocol (LACP) timer for port-channel in Cisco Application Centric Infrastructure (ACI). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |